two

config.py

@@ -96,6 +96,11 @@ ADC_LASER_THRESHOLD = 3000
 
 # ==================== 激光配置 ====================
 MODULE_ADDR = 0x00
+# 激光开关改由 A14 GPIO 控制：低电平开启，高电平关闭。
+LASER_CONTROL_PIN = "A14"
+LASER_CONTROL_GPIO = "GPIOA14"
+LASER_CONTROL_ON_LEVEL = 0
+LASER_CONTROL_OFF_LEVEL = 1
 LASER_ON_CMD = bytes([0xAA, MODULE_ADDR, 0x01, 0xBE, 0x00, 0x01, 0x00, 0x01, 0xC1])
 LASER_OFF_CMD = bytes([0xAA, MODULE_ADDR, 0x01, 0xBE, 0x00, 0x01, 0x00, 0x00, 0xC0])
 DISTANCE_QUERY_CMD = bytes([0xAA, MODULE_ADDR, 0x00, 0x20, 0x00, 0x01, 0x00, 0x00, 0x21])  # 激光测距查询命令
@@ -348,11 +353,29 @@ PIN_MAPPINGS = {
     "A28": "UART2_TX",
     "A15": "I2C5_SCL",
     "A27": "I2C5_SDA",
+    "A14": "GPIOA14",  # 激光开关：低开、高关
     "A24": "GPIOA24",  # 电源板关机控制
+    "A25": "GPIOA25",  # 电源状态绿灯
+    "A23": "GPIOA23",  # 电源状态红灯
 }
 
 # ==================== 电源配置 ====================
 AUTO_POWER_OFF_IN_SECONDS = 10 * 60  # 自动关机时间（秒），0表示不自动关机
+# 充电时自动关机暂时禁用；需要恢复时改为 True。
+CHARGING_AUTO_POWER_OFF_ENABLED = False
+
+# 一代电源控制：A24 由电源板负责按键/关机信号，软件关机时输出高电平。
+
+# 电源状态指示灯
+STATUS_LED_GREEN_GPIO = "GPIOA25"
+STATUS_LED_RED_GPIO = "GPIOA23"
+STATUS_LED_GREEN_ENABLED = True
+STATUS_LED_RED_ENABLED = True
+STATUS_LED_ACTIVE_LEVEL = 1
+STATUS_LED_LOW_BATTERY_PERCENT = 10
+STATUS_LED_FULL_BATTERY_PERCENT = 90
+STATUS_LED_CHARGING_BLINK_MS = 500
+STATUS_LED_POLL_MS = 1000
 
 BATTERY_SOC_LPF_ALPHA = 0.5
 BATTERY_SOC_AVG_WINDOW = 5